MEPT - a WSPR beacon: Unterschied zwischen den Versionen

VisuellWikitext

Version vom 1. Juli 2009, 10:34 Uhr

Vielseitige WSPR Bake für mobile und stationäre Anwendungen

MEPT = Manned Experimental Propagation Transmitter

Es dauerte einige Monate - aber jetzt ist es (fast) fertig.

Das Baken Konzept beruht auf getrennten Modulen die nach den speziellen Anforderungen kombiniert werden können.

Anschlüsse:

USB interface für die Windows Konfigurations Software
serial interface zum Anschluss der GPS Maus
SPI bus für die Datenübermittlung zwischen den Modulen
ICSP for in circuit serial programming of the PIC processor

Ausstattung:

Windows Konfigurationssoftware
Die Bake läuft unabhängig vom PC
Zeit und geographische Position werden hochgenau aus dem GPS Signal gewonnen
Unabhängige Generierung des WSPR Datensatz im Mikrocontroller der Bake
Bis zu 8 verschiedene Filter über eine Filterschaltbox anwählbar
Bis zu 4 Dämpfungsglieder Netzwerke durch die Abschwächer Box steuerbar
Mehrere DDS & PA Module an einem Controller anschließbar
DDS & PA Modul für 1.8-50MHz mit bis zu 15W
Bänder (160m / 80m / 40m / 30m / 20m/ 17m / 15m / 12m / 10m / 6m)

At the moment there are two modules. The CPU box with a DDS/PA module and a switch box that can hold up to 8 filter and one attenuator modules

Here you can find an overview of the possible configurations

MEPT CONFIGURATIONS

BASIC Configuration

The beacon system can be configured in various scenarios. The most simple one is the CPU unit with the integrated PA used stand alone. In this setup a LPF filter module is installed within the CPU box. So beaconing is only possible on one band. Either fixed - with pre programmed Locator - or mobile where location information is derived from the GPS signal.

400px

Multiband Configuration

In this setup the filter module in the CPU/PA module is removed and a Filter Switch Module is installed in the signal path. Through the SPI bus the CPU controls the Filter Switch Module. The module can hold up to 8 filter boards, hence enabling the system to transmit on up to eight different bands. Additionaly an attenuator module can be installed in the Filter Switch Module allow driving of a non resonant antenna. Again fixed and mobile operation is possible. In mobile applications usually a smaller number of bands will be choosen, optimizing probability to be heared at all.

Multiband Configuration with Attenuator Switch

Especially for fixed beacon operation transmittion with variable power levels on multiple bands is desired. In this configuration the multiband config is amended by a Attenuator Switch Module. This module can hold up to 4 attenuator boards and is controlled by the CPU through the SPI bus.

400px

Multiband Configuration with Multiple DDS/PA Modules

When running the beacon in Multiband config with a filter box with 8 boards installed, one will only reach a TX time of 12,5%. To increase the TX time to 25% (or higher) with still covering 8 bands (or more) additional DDS/PA modules with individual Filter Switch Modules can be driven from a single CPU. These signal sources can be attached to diffent antennas as shown, or through a LPF/HPF signal combiner into a single antenna.

MEPT CPU Modul

MEPT CPU board circuit

MEPT Display board circuit

MEPT DDS & PA board circuit

The main module holds the CPU with USB and GPS serial interface, the master oscillator and one DDS with a 15W PA module. It can be run stand alone and accepts one filter module on the RF unit board.